Add thrust vectoring capabilities to your 90mm Freewing F22! This kit includes the 3D printed parts to add thrust vectoring capabilities to your F22. 

Installation:

Carefully measure and cut out foam exhaust nozzles (all cuts chould be straight/square)

Make sure the control horns orient down and inboard and install each thrust vectoring assembly (already assembled held together temporarily with string if needed).

Measure forward of the control horns and cut out foam for 9g servos (not included in kit) then install servo inserts

Route servo wires into fan ducting, around the fan and into the forward avionics bay

Thrust vectoring capabilities will depend on controller capabilities (pitch vs pitch and roll)